Liuski Roger Caballero

Título

COMPORTAMENTO FÍSICO-MECÂNICO DE MATRIZES GEOPOLIMÉRICAS À BASE DE METACAULIM REFORÇADAS COM FIBRAS DE AÇO

Orientador(es)

Eduardo de Moraes Rego Fairbairn
Romildo Dias Toledo Filho

Resumo

No presente trabalho foram desenvolvidas matrizes geopoliméricas a partir da ativação alcalina de metacaulim, utilizando como ativadores NaOH e silicato de sódio. Foram utilizados dois lotes de metacaulim e areia natural para sintetizar as pastas e argamassas geopoliméricas. Compósitos geopoliméricos foram produzidos adicionando 1,2; 1,8 e 2,4% de fibras de aço inoxidável em relação ao volume total das argamassas, com o objetivo de avaliar o efeito do reforço no desempenho físico-mecânico dos compósitos. As matrizes foram analisadas mediante ensaios de compressão uniaxial e flexão em quatro pontos. A formação dos geopolímeros foi confirmada mediante análises de DRX e FTIR. Os sistemas geopoliméricos mostraram propriedades mecânicas, com resistências à compressão na faixa de 33-50 MPa, e à flexão de 1,5-12 MPa, sugerindo que esses materiais são adequados para substituir sistemas OPC em aplicações estruturais.

Abstract

This study is based on geopolymer matrices from alkaline activation of metakaolin, using sodium silicate and NaOH solution as activators. Two batches of metakaolin and natural sand were used to obtain the geopolymer pastes and mortars. Composites were obtained by adding 1.2, 1.8 and 2.4% of stainless steel fibers, in relation to the total volume of the mixture, aims of evaluate the influence of different contents of stainless steel fibers and their effect on the physical-mechanical performance of the composites. Matrices were tested under uniaxial compressive loads and flexural by four points bending tests. The geopolymer networks were confirmed by XRD and FTIR analysis. Metakaolin-based geopolymer pastes and mortars presented typical mechanical properties, with uniaxial compressive strengths ranging from 33 to 50 MPa and flexural tensile strength ranging from 1.5 to 12 MPa, suggesting that these materials are suitable to replace OPC systems in structural applications.

Print